Rewiring cables is the most common job in the repair of radio equipment. Due to prolonged operation, the insulation of the cores is disrupted, and cable cores often break. The cable is rewired if it has a length margin. When performing this work, they proceed as follows: Cut the threads of the cable ends with a knife and wind them up. The tips are soldered out, for which they heat up the junction with a soldering iron and remove the tip with pliers. If the cable cores are broken directly at the tip, then the core is cut again and the tip is soldered in the sequence specified in the previous section. If a core fracture has occurred at the base of the cable cutting, then the bottom of the old cutting is cut off and the cable is cut again. Due to mechanical damage and cable insulation violations, short circuits occur between the cores. The location of the damage can be found by the burnt insulation and the smell of burnt rubber. In this case, it is necessary to cut out the damaged section of the cable and fuse it. This is done as follows: Using a knife or wire cutters, make a circular incision in the top of the metal sheath of the cable and slide this sheath to one side and the other of the cable. Make two circular incisions with a knife, capturing the area of the cable breakdown, then make a longitudinal incision in the insulation and remove the rubber hose. This work is done carefully so as not to damage the rubber insulation of the cores. Having found the breakdown site, isolate each core with a layer of LSH-1 patent leather and two layers of insulating tape on top of the half-cover (it is necessary to isolate the cores for the entire length of the opened rubber hose). Isolate all the wires of the cable by wrapping two layers of insulating tape on top, and tighten the upper braid. A bandage made of tinned copper wire with a diameter of 0.5 mm is wound around the coil over the top braid of the cable so that it fits on the uncut cable hose on one side and the other by 12-25 mm. Using a hot soldering iron with POS-40 solder, the bandage is quickly soldered in separate places so as not to damage the insulation. If damage is repaired in a power cable that does not have an external metal shell, the work is carried out in the same sequence, only a layer of tape is wrapped over the insulating tape. 25 mm from the edge of the rubber hose on each side of the cut and along the entire length of the cut, the cable is sealed with harsh threads and a bandage of threads is coated with bakelite or shellac varnish on top. If the outer metal shell is damaged, a tinned wire bandage is wound around the cable at the point of damage and soldered in the initial and final turns. En définitive, ce sésame promotionnel est le compagnon idéal pour débuter votre aventure. Le code promo 1xbet rdc qui débloque 100% de bonus jusqu'à 130€ pour les paris sportifs ou 1950€ avec 150 tours gratuits pour le casino, est l'outil indispensable pour décupler votre potentiel de gains et enrichir votre expérience de jeu. Que votre préférence aille vers le frisson des paris sportifs ou l'excitation des jeux de casino, ce code vous octroie un avantage non négligeable. Pensez à le renseigner correctement lors de l'inscription et à consulter les conditions générales pour une utilisation optimale.